PROOFMATE® FD membrane

System component of the PROOFMATE® FD system. Sealing membrane based on EPDM (ethylene propylene diene monomer).

High elasticity even at low temperatures
High mechanical properties due to vulcanisation

The patented Proofmate FD System is ideal for reliably sealing joints and can be used simply and effectively above and even under water.

Technical Data
Material basis	EPDM
Thickness	1 mm
Shore A hardness	65 ± 5 (DIN ISO 7619-1)
Temperature resistance	150°C (long-term) 220°C (short-term)
Tensile strength	8,7 / 8,6 MPa (DIN EN 12311-2)
Elongation at break	531% / 483 % (DIN EN 12311-2)
Joint peel strength	69 N/50 mm (DIN EN 12316-2)
Joint shear resistance	282 N/50 mm (DIN EN 12317-2)
Resistance to impact	300 mm (DIN EN 12691)

PROOFMATE® F surface adhesive

System component of the PROOFMATE® FD system. Single-com-ponent mastic adhesive and sealing compound based on SPO
(SPO = silane terminated polypropylenoxide)

For surface adhesion of PROOFMATE® FD membrane to the structural component,
For surface adhesion of film-/film-over-lapping,
For edge sealing between PROOFMATE® FD membrane and structural element and in addition for overlapping.

Technical Data Sheet

Safety Data Sheet

Technical Data
Material basis	SMP
Consistency	pasty
Spec. density (23°C)	~ 1,5 g/cm3 (DIN EN ISO 2811-1)
Dyn. viscosity (23°C)	~ 2000 Pas (DIN EN ISO 2555)
Reaction data at 23°C
Processing temperature	5 – 40°C (substrate temperature)
pH value	~15 min (ASTM C679)
Max. grain size	~ 3 mm/24 h
Cured adhesive
Tensile strength	~ 1,3 N/mm2 (DIN EN ISO 527)
Elongation at break	~ 350 % (DIN EN ISO 527)
Shore A hardness	~ 40 (DIN ISO 7619-1)
Temp. resistance	-30 bis +80°C
Adhesion to concrete	> 1,65 N/mm2 (DIN EN 1542)